Hello:
I just purchased a 19997 skid summit 670. I am going through the sled to get it ready for use. I noticed on the pulley closest to the operator has about 1/8 end play. You can push it in toward the supporting flange bearing and pull back outwards. By looking at the drawings it shows a spring inside pulley on the flange bearing side. Should this spring open up the pulley to take up the slop or am I missing a shim.
I just purchased a 19997 skid summit 670. I am going through the sled to get it ready for use. I noticed on the pulley closest to the operator has about 1/8 end play. You can push it in toward the supporting flange bearing and pull back outwards. By looking at the drawings it shows a spring inside pulley on the flange bearing side. Should this spring open up the pulley to take up the slop or am I missing a shim.
