Diamond s outlet too small.

[ullose272]

My diamond s outlet is smaller than stock? Anyone else run into this?

Sent from my Pixel 3 using Tapatalk

 

[turboless terry]

I am guessing it can be smaller and achieve factory flows because it's less restrictive inside.

 

[ullose272]

I am guessing it can be smaller and achieve factory flows because it's less restrictive inside.

Ya, but what should i do about the gap in the bottom of my belly pan

Sent from my Pixel 3 using Tapatalk

 

[turboless terry]

Call them and see if you got the right one. Seems like it would have a flange that covers the hole. When I looked on their website, all I seen was 2 different ones for previous models.

 

[ak]

Just run it

 

[ullose272]

Just run it

Kinda what i was thinking, just curious if anyone else had seen this

Sent from my Pixel 3 using Tapatalk

 

[ak]

Yes mine is the same on my alpha and 850 skidoo, some of his early builds had the plate on the bottom, but caused cracks I believe so they removed it.

 

[sno*jet]

this is where diamond s went cheap.

 

[ndfb35]

They have always been small for the Ctecs. If you order the rubber piece from the older Pro Climbs and install it, it will seal it up. if you search back to the fall of 2017 there was a post about this.

 

[kanedog]

I fill the bellypan exhaust gap with permetex copper hi temp silicon/gasket maker stuff. If you spit on your finger, you can mold the silicone and shape it smooth for a nice, speed enhancing finish. I do this on all my sleds, Diamond s or stock.