d7 riser???

[cmud]

So I'm trying to put a taller riser on my 07 d7, everything has plugs except the left side controls, perc, heaters,etc. This bundle goes through the riser, and the other end doesn't appear to have a connector, untaped it a couple inches. ???? any help would be appreciated

 

[RMKJAY]

theres 4 torque screws at the back of the brake lever (towards the front of the sled) take them out and theres plugs in there when i did mine

 

[cmud]

Thanks, I seperated them and it looks like a couple plugs, do you have to pull up on the blue tabs to release them?

 

[RMKJAY]

just went and looked on mine they were gray and you just pull them out a little and then they unplug

 

[AK800VE]

on mine I used a small flat head screw driver to push the little tabs in and pulled the plugs out

 

[cmud]

Thanks again, took a flathead and stuck it in the bigger gap, it releases the plugs, all is good now. I went with 6" mountain machines risers, I think it will be about perfect. Can't wait for winter, snow levels 3500....

 

[Tommy72]

Any more room?

Thanks again, took a flathead and stuck it in the bigger gap, it releases the plugs, all is good now. I went with 6" mountain machines risers, I think it will be about perfect. Can't wait for winter, snow levels 3500....

By the way, did you had to extend any wires or cables? If no, how much more do you think you can go?

thanks,
T

 

[Ollie]

6" is it.
If you want to go any higher you have to start messing with wiring, rerouting and other "stuff".

 

[Snocross 100]

Auto wiring!

There is only 7 wiers going down the post so I made 6" wire extentions for just the 7 and crimped them in and it works perfect!