Cutting track to fit the hawk

[Givemeaboost]

My buddy just bought a 144'' track to put on his hawk and we need to figure out how to cut it on a tablesaw. We tried to turn it inside out but that didn't work so we're going to raise the saw off the ground and run the track underneath so we can cut it with the outside up. Does anyone know what kind of blade we should use to do this?

 

[Hawkdoggen]

you want to use at lest a 46 tooth carbide bit , set your fence at about an 1/8" less than you want to cut . its easy if you have one guy feed ( use a stick to push) , one guy pull and one guy with about a 16 " peice of 2x4 to hold track up in centre while holding it down against the blade then just go slow !

 

[Beeline]

Search utube . Search our posts as well .I have seen the video .