CPC Dragon 1000 Trail/Race Motor
In hot trail form it will exceed 200 hp and 135 foot lbs. of torque. In race form over 215 hp. Entire engine is hardly used and fresh. Comes with adjustable compression cylinder head domes with 3 extra sets that have not been cut yet. Also included is stater and fly wheel and transplants into your 03' - 06' F6/F7/M6/M7 chassis. This comes compete with like new 1000cc CPC twin race pipes including fairly quiet silencers (normally $775). Also, this is not just a run of the mill big bore kit. The entire engine was done by CPC. Crank is balanced, pinned and welded. Crank case is blueprinted and machined. Huge CPC race power valves. All work performed on a new case and crank (rods, ect.). If installed in fuel injected sled contact CPC for the EFI chip which is $234 (part # cp-001-80105).
To just buy the kit from CPC minus the shipping it will cost you over $6000 to turn your F7 motor into this.
Priced to sell at $1,950
Contact Matt with questions. 715-790-8009.
Buyer pays shipping.
In hot trail form it will exceed 200 hp and 135 foot lbs. of torque. In race form over 215 hp. Entire engine is hardly used and fresh. Comes with adjustable compression cylinder head domes with 3 extra sets that have not been cut yet. Also included is stater and fly wheel and transplants into your 03' - 06' F6/F7/M6/M7 chassis. This comes compete with like new 1000cc CPC twin race pipes including fairly quiet silencers (normally $775). Also, this is not just a run of the mill big bore kit. The entire engine was done by CPC. Crank is balanced, pinned and welded. Crank case is blueprinted and machined. Huge CPC race power valves. All work performed on a new case and crank (rods, ect.). If installed in fuel injected sled contact CPC for the EFI chip which is $234 (part # cp-001-80105).
To just buy the kit from CPC minus the shipping it will cost you over $6000 to turn your F7 motor into this.
Priced to sell at $1,950
Contact Matt with questions. 715-790-8009.
Buyer pays shipping.
Last edited:
