Complete Nytro Motor for Parts

[n2otoofast4u]

Has Carillo rods, and ported head. This was a slow death not a sudden lock up. Not sure what it's worth. 600 shipped?

 

[Snowman87]

How much damage to the ported head?

 

[n2otoofast4u]

How much damage to the ported head?

Looks like it's pretty easily fixed...........but I'm not a machinist. I can take a close up if needed.

 

[n2otoofast4u]

Bump. Still have this. Had lots of interest last time but the ridiculous questions came at an overwhelming rate.

What you see is what you get. I don't know what is good or bad, I don't know what it will cost to fix, I doubt you can bolt it back together and run it.

 

[SNWMBL]

Here's what I want, a gutted block that I can use for building my next chassis. Don't need or want any internals, just a completely gutted block.

Would need the block(with motor mounts still attached), head, crankcase cover, oil pan, water pump & starter. If you're willing to pull the heavy stuff out of it then send me a PM with how much you'd want for it shipped to Anchorage, Alaska 99516.

Maybe you could sell the internal parts separate.

 

[n2otoofast4u]

I have no time to disassemble, decide what's good or not, and so on. If it doesn't sell as is I'll scrap it.

 

[SNWMBL]

Well if you get to the point of scrapping it then maybe we can work something out. I just don't want to spend that much on something I'll only be using in a jig.

 

[Snowman87]

I have no time to disassemble, decide what's good or not, and so on. If it doesn't sell as is I'll scrap it.

Where are you from? I'm interested too and would pay more than scrap price, but couldn't justify spending $600 to put it on the shelf for now.

 

[n2otoofast4u]

TTT