2006 summit 800 will only hit 7600-7800. The clickers don't seem to make a difference. The clutches are in good shape. Any ideas what could cause this. Thanks
clutching
- Thread starter CLAYL
- Start date
R
rstephen0424
New member
how many miles, snow condition/ type of riding , your weight, hot and cold compression test is your motor healthy.... take the set screws out of your pins, clickers are just going to change how fast it revs and how hard it pulls not necessarily your wot rpm
Make sure your RAVE valves are clean and the bellows are not cracked or have popped off. Also all hoses still connected to the RAVE valves. One of the spring things that hold the bellows on mine had popped off and it wouldn't go to full revs.
The rave valves were an issue before but they have been fixed. I put a short block in it about less then 500 miles ago. Replaced bushings in clutches last season and springs are a couple seasons old. Has a dynamo clutch kit. It is a back up sled,I don't use very much. It worked fine before the short block but since is limited rpms. Thought it was the rave valves because only one was opening but they're fixed now. This set-up is what was in the dynamo joe clutch kit. May give him a call on days off. Thanks
Long shot but, are your lights working!
Lights are working. Everything is the same as it was before the shortblock except putting in the new bushings when I started having the rpm trouble.
