Brand new motor won't start 07 M8

[dubbs]

Got my brand new replacemant motor in and the new turbo kit all installed... And I'm not getting any voltage to fuel pump or anything for that matter... (well anything that should be getting 12 volts..) It has spark...All the connectors done up right, everything is grounded proppertly... Checked the fuse on the chassy control module it's good...

Checked all the resistances of the coils and they are good...

So wondering if anyone has seen this but when I pull it over, the wrench icon lights up and that's it...

Can't seem to find anything in the manual about it... Anyone seen this before?

 

[dubbs]

I guess my meter was just not fast enough to read the voltage while I was pulling it over... Thought it would be??

Primed the motor and it finally got fuel pressure... And all was good... Good thing I wasted 5 hours taking everything apart and checking everything...

The fuel pressure reg was set quite low... I think this was part of the problem... I pinched off the return line and that seemed to help get some pressure happening faster... If anyone else has the same prob...