Box-stock 06 900 RMK, where do I start?

[Jim Green]

I have an 06 900 RMK 151 with app. 500 miles on it. No problems so far other than the gas tank replacement. Fairly handy with a set of wrenchs, but where do I start with mods to make this a trouble free sled. Is there any type of manual out there, or a list of what needs to be done?

 

[KJ55]

Start with push/torque arm kits and the compfusion motor mounts. Then of you are on a budget gut the airbox for a little more power. I would also get a vent kit to keep your sled running cool. I am no expert but there are great people here that will help you with wiring stuff and clutch setup.

 

[06 RMK 900]

READ THE STICKIES IN THE 900 FORUM IT'S ALL THERE.

 

[guidoxpress]

compfusion mounts, billet front crossmember, BALANCE YOUR PRIMARY clutch, change your stock helix, clutch it properly if its never been done.

check your intake boots for cracks, cover them with heat tape to prevent them from cracking from heat on the y-pipe.

gut your stock air box

check your TPS setting

pull your motor when you get time and go over the wiring and protect it from chaffing ect..

lots of other info and ideas out there...read up bud

 

[sleddude]

Gear it down and add the SLP torque arm and torque stop, get a vent kit and make sure you run the 115 belts to start with. Should hit 7650 on your rpms.