Bmp fat *** pipe and elevation

[mudracer]

At what elevation would you not run this pipe and use the factory altered one from bmp? This is on a m8 and going to west yellow stone. Thanks

 

[Proven]

I would not run it an any elevation above the bottom of the nearest dumpster

 

[Evolution Powersports]

^^^^^^^^^THAT is Funny chit ^^^^^^^^^^^^^

 

[bluebear]

Is it an M8 big bore? On my M8BB I did not run the fat azz pipe, just their single pipe and it ran good. Above about 5K ft I would switch to the smaller pipe.

Pay no attention to the typical dumb $hits.

 

[orange06m7]

I would not run it an any elevation above the bottom of the nearest dumpster

LOL. i have to agree with you

 

[TS Drag Racer]

I would not run it an any elevation above the bottom of the nearest dumpster

X3 I just replaced mine with a Speedwerx. With my Power Commander, I was able to make mine run with the BMP pipe, but the Speedwerx is much snappier on the bottom end and easier to tune.

 

[heinens1]

X4 on the bmp pipe I wouldnt run it off your trailer unless you have alot of time to tune and can always be in that 100-150 rpm sweet spot were it makes a few more hp than stock good luck with it I know I spent a day at the Dyno run a speedwerx or straightline pipe wide powerband and easy to clutch and tune My 2 cents if you call BMP they will just tell you you need more of their chat!!!

 

[WyoBoy1000]

x5 right up @$$ of the person that sold it to you.