I took my exhaust off to check some things and noticed I have a good sized hole in my belly pan directly above the right shock. Looks like the exhaust pipe melted it and I can't see how to make any room between the pipe and that spot. I was thinking of covering/sealing the hole and just lining the crap out of it with heat tape. Any other suggestions? I am looking to replace the whole belly pan if anybody has or knows of one. Thanks
Belly Pan help
- Thread starter CHIA_PET74
- Start date
Do you have the stock pipe or an aftermarket pipe?
The space there is controled by the little rubber bumper on top of the shock tower mount. Check to see if it is gone or melted. You can add washers under it to pick the pipe up, just make sure and not pick it up so far it touches the hood.
You can repair that hole in a couple of ways, easiest is to just get a piece of belly pan plastic and rivet it in place then heat tape over it.
sled_guy
The space there is controled by the little rubber bumper on top of the shock tower mount. Check to see if it is gone or melted. You can add washers under it to pick the pipe up, just make sure and not pick it up so far it touches the hood.
You can repair that hole in a couple of ways, easiest is to just get a piece of belly pan plastic and rivet it in place then heat tape over it.
sled_guy
