Alright, who here can help with with finding the correct plug for the Axys headlight? Needing the female connection on the headlight it self.
AXYS HEADLIGHT CONNECTOR
- Thread starter AKFULLTHROTTLE
- Start date
I just ordered some pins, seals and connector bodies from Newark electronics this week for my tether install. (axys 850) It took some homework but parts were cheap and no minimum order qty. Good pictures on the site to help with connector identification.
I used this to plug into the hood harness for a headlight delete. I used the low beam wire and connected it to a resistor to scrub off the excess power.
https://www.snowest.com/forum/showthread.php?t=430757
Well that looks like what I am looking for! Expensive little guy!
It can be found for around $35 or so, but it was super easy to clip off the wires I didn't need vs. fumbling around trying to assemble the connector from scratch. At that time, I didn't have the required tools to assemble these types of connectors, I do now, so I would probably buy the required pieces needed to assemble the connector.
Ya just ordered the GM one from Amazon. Not to bad. Going to run other lights from it with my skinz hood.
No but should be able to figure out with a volt meter.
I looked at the schematic. Here's the wiring on the hood harness headlight connector:
Position A: Yellow/Red - High Beam
Position B: Brown - Ground
Position C: Red/White - DC Power (low beam)
You Da man!
Similar threads
