Finally installing a camo extreme and avid drivers to replace my crappy stock track. I've got everything apart and have the acids pushed on the driveshaft, thought I measured correctly but apparently not as they're not lining up. I was hoping someone would have the proper dimensions to help me out and make this process a little faster, thanks.
Avid driver install?
- Thread starter Powder Man
- Start date
P
paulharris
Well-known member
hopefully you marked the centerline on the driveshaft of where the old drivers were located before you pressed them off. NOT the center of the driveshaft when measured from the ends, but the center of where the stock drivers were located. Then 4.5 inches from that center mark on your driveshaft to the center of each driver. 9 inch spacing between the avid drivers.
Last edited:
I measured from both ends of the driveshaft to the outside hub of the stock anti ratchets. Talked to Robbie pretty sure he got me straightened out. If anyone has measurements from the ends of the driveshaft to the outside hub of the avid drivers that's what I'm really looking for, thanks.
That's a big help, thanks auto pro.
what model of sled?
