Arctic Cat m series m7 m1000 front shocks
Front shocks with orange springs for m series. Great shape.
Also have the following:
2005 M7 Chassis parting out while you guys are in the midst of breaking parts. Initial asking pricing on the parts will all be at 50% of new price so that it makes it easy to go through them. You can use any dealer with an OEM parts search engine. I am basing my pricing on our local dealer linked here. http://www.mtbakermoto.com/fiche_sel...005&fveh=11110
2005 M7 162" bulkhead and tunnel with snow eliminators
Front shocks w orange springs
Vented M-8 hood has a crack and scratches at the tie down area on the right but otherwise has frogskins in place and in good shape, Windshield has a crack also.
Moto Tassanari V-Force III reeds - some feathering on 2 of tips but does not leave a gap
Speedo, computer, fuel rails
Chassis has about 2900 miles total
Actually, it would probably be easier to just list the parts I don't have right now. So here they are:
The air plenum is not attached to the hood as this was used with BDX box. I have a brand new assembly from my 1000 if you want it along with the hood.
No oil injection pump, magneto, or recoil mechanism.
No steering post
No clutches
No rear suspension
No spindles or bolts for the front suspension or steering linkages
No bumper/nosecone
I think it has everything else but this will be updated as time goes on.
The motor was a Cutler 1000 that ended its life by losing both the bottom and the top end. I sold it as a core essentially. The only trades I am really interested in would be SLP or Speedwerx pipes, etc.. I already have a Speedworks y pipe and SLP can but would be up for an entire pipe set-up from either manufacturer.
Front shocks with orange springs for m series. Great shape.
Also have the following:
2005 M7 Chassis parting out while you guys are in the midst of breaking parts. Initial asking pricing on the parts will all be at 50% of new price so that it makes it easy to go through them. You can use any dealer with an OEM parts search engine. I am basing my pricing on our local dealer linked here. http://www.mtbakermoto.com/fiche_sel...005&fveh=11110
2005 M7 162" bulkhead and tunnel with snow eliminators
Front shocks w orange springs
Vented M-8 hood has a crack and scratches at the tie down area on the right but otherwise has frogskins in place and in good shape, Windshield has a crack also.
Moto Tassanari V-Force III reeds - some feathering on 2 of tips but does not leave a gap
Speedo, computer, fuel rails
Chassis has about 2900 miles total
Actually, it would probably be easier to just list the parts I don't have right now. So here they are:
The air plenum is not attached to the hood as this was used with BDX box. I have a brand new assembly from my 1000 if you want it along with the hood.
No oil injection pump, magneto, or recoil mechanism.
No steering post
No clutches
No rear suspension
No spindles or bolts for the front suspension or steering linkages
No bumper/nosecone
I think it has everything else but this will be updated as time goes on.
The motor was a Cutler 1000 that ended its life by losing both the bottom and the top end. I sold it as a core essentially. The only trades I am really interested in would be SLP or Speedwerx pipes, etc.. I already have a Speedworks y pipe and SLP can but would be up for an entire pipe set-up from either manufacturer.
Last edited:
