anyone tested these collars yet

[samtarolli]

Just wondering if anyone's actually tried these collars available? Everyone has already speculated on whether or not they will work or not, I am wondering the actual results people are getting.

On a different note, I checked my glue today and i was hard, but could be cut with a utility knife without excessive force, same consitency as grey glue on the lower a arm. I was expecting it to be more like hardened epoxy. It was also close to 0 degrees out so this is a little concerning

Got .8 miles around the neighborhood haha, waiting for some snow to try this thing out

 

[Jeff K]

Actual results? I have one installed and my shaft hasn't broken. Would it have broken without it? No idea. I haven't heard of one shaft failure where a clamp was installed yet, so more than likely they help. Buy one and enjoy your sled until Polaris figures this mess out.

 

[bigdave]

I am putting my clamps on tonoght. Rode 35 miles or so yesterday and no problems but i dont trust it and that sucks..Hope all the guys that have broken shafts are getting updated new ones. but i did hear of a replacement shaft breaking too...bull****....Poo Step up and fix this sh**

 

[samtarolli]

So far all the pics of broken shafts I have seen on here look like a collar could have prevented them (the steel hex turning and stretching the aluminum and the next stage where it blows apart) has anyone seen any pics of different kinds of failures or are they all similar?

 

[snowmobiler]

wait and see what DLYNN has.

 

[cjfox]

60 miles without 45 with clamp time will tell, I got the rk tek one I saw a couple other guys that made em 100 bucks

 

[dr63pro]

Collars

where do you get these collars?

 

[skibreeze]

where do you get these collars?

RK Tek.

 

[tudizzle]

RK Tek

www.2strokeheads.com