Hi,
I am in the process of installing a M10 144 W2 Air in my apex that I stretched - I am getting ready to mount the suspension and the measurements do not seem right! The front hole is 5.059 back from the flat of the drive shaft and just over 6 down from the top of the tunnel - this puts the front arm slightly above the drive shaft. The rear has a drop of just over 7 inches - it barely sits below the bottom of the tunnel - there is no way my cr m10 plates will work, for one they are way to long (easy to cut them down) and they put a rear drop of about 8.5 inches vs. the 7 Team Fast is calling for. Any information would be greatly appreciated, I want to mount this skid once!
I am in the process of installing a M10 144 W2 Air in my apex that I stretched - I am getting ready to mount the suspension and the measurements do not seem right! The front hole is 5.059 back from the flat of the drive shaft and just over 6 down from the top of the tunnel - this puts the front arm slightly above the drive shaft. The rear has a drop of just over 7 inches - it barely sits below the bottom of the tunnel - there is no way my cr m10 plates will work, for one they are way to long (easy to cut them down) and they put a rear drop of about 8.5 inches vs. the 7 Team Fast is calling for. Any information would be greatly appreciated, I want to mount this skid once!
