Well ended up with a 05 900 fusion. Ended up trading a meyer snow plow for it.(plow cost me nothing). Anyways sled was torn down when i got it. Need exhaust valve piston and cylinder. Sled has 2500 miles. Almost mint condition. Got everything together and will only run on the mag cylinder. Sled did set for about 2 years. about a year torn apart. If i put a little gas on the pto cylinder it will fire. Has great spark. Could it be just a plugged injector? Thanks for any help.
900 no fuel on pto side
- Thread starter rhefler
- Start date
Pull the injector out and have them flow tested and cleaned but before you send the injectors away check the wiring on the injectors themselves for cracks in the insulation... Best of luck to ya
Sent from my HTC One X+ using Tapatalk
Sent from my HTC One X+ using Tapatalk
Where can i send them? I will need to pull motor to get to them?
The sled was running when the exhaust valve broke taking the piston. so hoping it just needs cleaned after sitting. The gas was bad.
http://www.witchhunter.com/ I found to be the best place so far. I was pointed to these guys from Guidoxpress. They do a nice job and don't bs ya on anything.
does anybody know how to check these injectors? ohm reading is 12.3
Last edited:
Got sled done. Was a stuck injector. Pulled motor pulled injector and cleaned on bench. Runs like a dream.
