Used Land-and-sea 9" dyno-mite snowmobile dyno. This fits Arctic cat 33mm cranks (m7's, M8's, M1000's, KK 900's, etc)
www.land-and-sea.com/
It comes with
Dyno,
Handheld dyno computer
Software to hook up to PC
Manual control valve,
Servo control valve
3 EGT Sensors
Fuel Flow Sensor (get BSFC #'s)
Boost Sensor
Water Temp Sensor
Weather Station (automatic HP correction)
Magnetic RPM Pickup
Rev Limiter
Watercraft testing gearbox
All in a nice carry case. I used this to tune my turbo, I made a kit from scratch, ran it on the dyno during the summer / fall, and never had to do any tuning on the hill, this is definitely worth the money!
I only used the dyno, handheld computer, and manual servo. I was not smart enough to figure out how to get the rest of the stuff to work. I have full documentation, manuals, etc.
It gets your HP and torqe numbers very easily this well and allows you to load up your sled on the trailer!
The dyno is supposed to be able to run all of these sensors together and give you the data back. You can also input an external sensor like a wideband o2. New this setup cost over $10,000. Asking $2000
Dyno is in Northern Utah
www.land-and-sea.com/
It comes with
Dyno,
Handheld dyno computer
Software to hook up to PC
Manual control valve,
Servo control valve
3 EGT Sensors
Fuel Flow Sensor (get BSFC #'s)
Boost Sensor
Water Temp Sensor
Weather Station (automatic HP correction)
Magnetic RPM Pickup
Rev Limiter
Watercraft testing gearbox
All in a nice carry case. I used this to tune my turbo, I made a kit from scratch, ran it on the dyno during the summer / fall, and never had to do any tuning on the hill, this is definitely worth the money!
I only used the dyno, handheld computer, and manual servo. I was not smart enough to figure out how to get the rest of the stuff to work. I have full documentation, manuals, etc.
It gets your HP and torqe numbers very easily this well and allows you to load up your sled on the trailer!
The dyno is supposed to be able to run all of these sensors together and give you the data back. You can also input an external sensor like a wideband o2. New this setup cost over $10,000. Asking $2000
Dyno is in Northern Utah
