800 base line carb setup?

[joshkoltes]

whats an average carburator baseline for the liberty 800 edge? mine wont run and ive been all over the screws, rebuilt the linkages, new needles. and it still has the same dead spot on the bottom. wont even idle right.

when i got it it had 9dgj2-57main needles but it is supposed to have 9dgn06-57. so i changed that. no improvement

so what jets, needles, or screw set work at 8000 ft with a full single pipe set?

 

[joshkoltes]

proper

so with the proper needle in it and all the new linkages, now it dosnt even want to move. it definitely runs worse. wonder if i should tune with the mystery needle?

 

[shawkins]

Use the DGN needle for sure. The other needle is way lean.
Fuel screw 1 turn out
Air screw 3/4 turn out
Needle in the 4th position
340 main jets with SLP single.
If it will not run right with that setup something is wrong. I've set up lots of edge 800's with that exact setup 6-10,000 ft.