Will it fit with a powder Max track from a XP?? What do you guys think?? Thinkin about trying one for kicks.....
8 tooth 2.86 pitch drivers in a nytro??
- Thread starter Thistledoo
- Start date
Will it fit with a powder Max track from a XP?? What do you guys think?? Thinkin about trying one for kicks.....
I have heard people say that if you have or are going to boost, camo extreme is the best bet. Not sure what your setup is though.
MCX boosted.....I have a maverick now and like it. I like the looks of the powder max track....just wanna know if it will phyisically fit??
Thistledoo
Stock MTX 7 tooth 3" pitch drivers are 6.685" (170mm) diameter
8 tooth 2.86" pitch drivers are 7.283" (185mm) diameter. If that helps.
There is a post in the MTX forum on TY, that has driver diameters listed. I'd do the linky thing if I could figure out how
Stock MTX 7 tooth 3" pitch drivers are 6.685" (170mm) diameter
8 tooth 2.86" pitch drivers are 7.283" (185mm) diameter. If that helps.
There is a post in the MTX forum on TY, that has driver diameters listed. I'd do the linky thing if I could figure out how
C
carbondaddy
Well-known member
I'm running the 163 powdermax in the Turbo Skamaha (Vector powered). The track works very good in powder and setup snow. I'm using skidoo drivers (part #504152552), they are an 8 tooth extrovert and fit the Yamaha drive shaft. Other than loosing a few track clips it's held up well. Not too sure with the 16" width in the Nytro chassis though. I know you can get them in there, but it's tight.
Thanks guys...been runnin a 16 wide mav all year and it fits fine....not sure if I need another track either but hey just thinkin of summer mods
