600HO clutch alignment

[Duff]

Sled is a Fusion 600HO with a donor motor. Belt was squealing so I checked the alignment and it doesn't look good. According to SLP the bar should be alot closer to the back of the secondary and my C-C measurement should be 11'' with the tape butted up to the jackshaft. So what do I do to correct this? There doesn't seem to be any adjustment with the mounts.

 

[Kraven]

Sled is a Fusion 600HO with a donor motor. Belt was squealing so I checked the alignment and it doesn't look good. According to SLP the bar should be alot closer to the back of the secondary and my C-C measurement should be 11'' with the tape butted up to the jackshaft. So what do I do to correct this? There doesn't seem to be any adjustment with the mounts.

Check for broken motor mounts first.

After that check my TECH TIPS thread & Engine/Clutch Alignment Threads under "INCREASING YOU IQ" at the top of this section.

http://www.snowestonline.com/forum/showthread.php?t=152478

AND with pics

http://www.snowestonline.com/forum/showthread.php?t=177443

Slotting the engine brackets MAY be required, but once again check your mounts, etc, that seems really off!