2016 axys jackshaft
- Thread starter jhurkot
- Start date
Anyone busted a jackshaft yet? This happened at 1500 miles.
Sent from my iPhone using Tapatalk
Quickdrive or chaincase?
Hard to tell from the angle of that pic, but guessing that is where the solid end is welded to the tubular center section. It will more obvious once you get further into it.
800 HO
I was thinking the same thing, looks like the weld let go but it's hard to tell from that pic
Originally I looked at the pic and thought you had something was more serious going on since the secondary "stub shaft" is at an angle. But then it dawned on me that when tou break the shaft the belt tension should pull the secondary towards the primary since that bearing will deflect a little
If it warranty and should be I would think, get th to change out that bearing on the secondary side as well as check everything on the input side of the quick drive. Might as well get them to verify alignment on the qd after. Wouldn't want to start throwing qd belts now because of poor alignment
Originally I looked at the pic and thought you had something was more serious going on since the secondary "stub shaft" is at an angle. But then it dawned on me that when tou break the shaft the belt tension should pull the secondary towards the primary since that bearing will deflect a little
If it warranty and should be I would think, get th to change out that bearing on the secondary side as well as check everything on the input side of the quick drive. Might as well get them to verify alignment on the qd after. Wouldn't want to start throwing qd belts now because of poor alignment
So just to clarify, the shock absorber bolt fell out causing the jackshaft to break?
The pic is indeed of the Jack shaft.
