2013 PRO RMK TEATHER INSTALL

[8mycash]

WOULD LIKE TO WIRE MY TEATHER SO WHEN I REMOVE THE HOOD THERE WOULD BE NO EXTRA WIRING TO REMOVE, WHERE AND WHAT COLOUR WIRES ARE WE LOOKING FOR?

THANKS JASON

 

[Jeff K]

http://www.snowestonline.com/forum/showthread.php?t=281923&highlight=tether

 

[8mycash]

TTT

 

[die hard poo]

Same location as the 11/12, but has different wire colors, here is what alscat1 found:
"Looks like the empty connector behind bars with black wire and another black wire with blue tracer is the connector"...

 

[bdoe22]

pro-design

I am going to be installing a pro-design tether on my '13 pro instead of the plunger type. Anybody making just the connector for the tether side so i can just plug it in and dont have to cut and splice the factory harness?

 

[mountainhorse]

I think these are simple GM or Molex spade connector housings on the tether??

http://www.ronfrancis.com/products.asp?dept=58

 

[Jeff95]

Are the Pro RMK Normally Open or Normalyy Closed?

Jeff

 

[alaska907]

Are the Pro RMK Normally Open or Normalyy Closed?

Jeff

I believe they are open.

 

[Ski-Dont89]

I think these are simple GM or Molex spade connector housings on the tether??

http://www.ronfrancis.com/products.asp?dept=58

If i could figure out which connector to buy that would be stellar...would make my pro design tether a much cleaner install and plug and play...its almost worth it to me to buy the polaris tether just to rob the connector off of it so i can splice it on to the pro design tether

 

[Aussie Niko]

Pretty sure its number 2 on the list, I will check tomorrow as I'm also wanting to do this wiring mod.

 

[rick5150]

I ordered the #2 off eBay from them this morning...appears to be the one...time will tell

 

[92 coupe]

on my assault the connector is a 2 pin side by side, number 2 appears to be a T arrangement unless the link is a generic pic?

 

[Techsledder]

Is this the connector?

 

[92 coupe]

yes sir

 

[Ski-Dont89]

I ordered the #2 off eBay from them this morning...appears to be the one...time will tell

link?

 

[Danbot]

No need for a special connector. I soldered a regular spade connector on each wire on my Pro Design tether, and plugged them into the connector plug mentioned above with the black and black/blue wires. (2013 pro)

 

[AaronBND]

Did we ever find this connector to plug into the Polaris harness? I to got the Pro-tether and want to make it clean.......

Aaron

 

[Ski-Dont89]

Did we ever find this connector to plug into the Polaris harness? I to got the Pro-tether and want to make it clean.......

Aaron

x2!

 

[Danbot]

On the 2013's its a 2 female spade connector under the hood inside the wiring pouch. One wire is black, the other is black with a green tracer. Just solder male spades on the end of your pro design tether wires, plug them in and GO!

 

[rick5150]

x2!

It's not the right one I ended up using it on my truck lol
For the sled just like mentioned before male spade connectors plug right in