Just found out that Polaris had a problem with the glue mixture that was used on some sleds when they put the drive shafts together
You can flip your sled on its side and looking at the drive shaft there is a small weep hole on both sides --there is a small amount of excess gray glue --if the glue is hard you are good to go --if the glue is soft you have a problem
Polaris keeps grasping at straws here. What was it last week? Forklifts used by the dealers? What will it be next week? Most riders with failed driveshafts, do not appear to be checking the hardness of the glue mixture. Skibreeze reports that he witnessed a driveshaft failure where the glue mixture was HARD. Post #180 on this page:
http://www.snowestonline.com/forum/showthread.php?p=3200378#post3200378
One person relayed his suspicious conversation with his dealer and the dealer appeared to be programmed to instruct the frustrated owner to put in a steel driveshaft, without himself admitting that the 3 piece bonded driveshaft has any defects whatsover. I doubt whether Polaris wants to get into a class action lawsuit, so their attorneys are likely recommending that they not admit that there is anything wrong with the driveshafts. Attorneys are running the show now. Polaris is just sitting on their hands, hoping for the problem to become less of an issue once the season gets underway and perhaps some initially defective driveshafts get weeded out, or some other defective part takes the spotlight. If it was a suitable design with sloppy quality control in the assembly, then the problem may go away. But if it was a poor design with even poorer quality control, it won't go away. It will get worse. Had Polaris tested these last spring, they would already know the answer to that question.