2007 600 SDI died on me....fuel line?

[cmantle1]

so i have a 07 600 SDI with 250 miles. today right before the truck (30 feet?) it died. it was running, then lost all power. i shut it off then tried to restart it and no dice. it was very cold, on 1/4 tank, and latley i have not been putting iso heet in the tank. do you thinka frozen fuel line is my problem? any way to check that beside thawing the sled out?
thanks
chris

 

[nonstock]

i have an 05 rt1000 that did the exact same thing. got it to the parking lot and got of to start the truck and it died, trie starting it and it would start for a half second and then die. turned out the battery was dead. don't know if that helps but that is my 2 cents. good luck!

 

[cmantle1]

i have an 05 rt1000 that did the exact same thing. got it to the parking lot and got of to start the truck and it died, trie starting it and it would start for a half second and then die. turned out the battery was dead. don't know if that helps but that is my 2 cents. good luck!

thanks, anyway to check that? the sled is under warranty but the nearst dealer is an hour away so if i can fix it at home it would save alot of BS.

 

[H20SKE]

If not the battery--check the fuel pump.

H20SKE...

 

[cmantle1]

If not the battery--check the fuel pump.

H20SKE...

how do i do that?

 

[AkSummit]

how do i do that?

press the little gray button and listen up to see if you hear the fuel pump charge the lines. it sounds like a loud hum.

check all your wiring conections. when stuff like this happens just realize its always most the simplest things. make sure your plug wires are on tight and that your des key is attatched.

if it was running fine before its got to be the simplest thing. just give it a good check.

 

[cmantle1]

ok thanks for all the input guys. today i put some heet in it, let it thaw out a bit, and did a complete check over everything. on the third pull it started, but then shut down. 6 pulls later it fired up. let it idol for a few minutes and then took it around a field, and it ran fine. no its been starting first pull...