2004 Firecat F7 Nightfire LE with factory EXT 144 kit. 3670 miles $3600
There were very few of this machine built. The entire hood, tunnel and skid were blacked out from the factory. Machine is curently located in Idaho Falls, Idaho but can be shipped or transported.
• New pistons, rings, water pump, bearings with custom lightweight wrist pins
• Crankshaft rebuilt and trued. Cases measured and blueprinted.
• V-Force III reeds
• All new electrical components including stator, coil and wires, caps and plugs
•MSD low resistant wires and crimped caps
• Rear skid has been completely inspected with all new bearings and rebuilt shocks
• New front and rear suspension bushings and fresh grease
• Chassis has been completely disassembled, inspected and reassembled
• Throttle bodies have been synchronized, TPS calibrated to Cat specifications
• Clutches completely rebuilt to new condition and re-balanced
• Alignment and offset have been perfectly set
• Arctic Cat factory race track 144”x14”x2” reversible finger track
• Custom ArcticFx wrap
Here is a list of optianal parts:
• SLP race ported cylinders which have been flow matched to the cases
• Two sets of SLP race pipes. One set cut for running higher RPM. One set ceramic coated
•V-force III reeds
•Trail pipes
•Race heads
•Team Tied Clutch
•O2 guage
•Powder Pro or SLT Ski's
This machine has had about 1.5 hours on the new motor. Chassis and motor have been completly gone through from top to bottom and are in excellent condition. Machine can be sold with many extras or with the basics…. priced according to options included. PM or call me @SLP for details.
There were very few of this machine built. The entire hood, tunnel and skid were blacked out from the factory. Machine is curently located in Idaho Falls, Idaho but can be shipped or transported.
• New pistons, rings, water pump, bearings with custom lightweight wrist pins
• Crankshaft rebuilt and trued. Cases measured and blueprinted.
• V-Force III reeds
• All new electrical components including stator, coil and wires, caps and plugs
•MSD low resistant wires and crimped caps
• Rear skid has been completely inspected with all new bearings and rebuilt shocks
• New front and rear suspension bushings and fresh grease
• Chassis has been completely disassembled, inspected and reassembled
• Throttle bodies have been synchronized, TPS calibrated to Cat specifications
• Clutches completely rebuilt to new condition and re-balanced
• Alignment and offset have been perfectly set
• Arctic Cat factory race track 144”x14”x2” reversible finger track
• Custom ArcticFx wrap
Here is a list of optianal parts:
• SLP race ported cylinders which have been flow matched to the cases
• Two sets of SLP race pipes. One set cut for running higher RPM. One set ceramic coated
•V-force III reeds
•Trail pipes
•Race heads
•Team Tied Clutch
•O2 guage
•Powder Pro or SLT Ski's
This machine has had about 1.5 hours on the new motor. Chassis and motor have been completly gone through from top to bottom and are in excellent condition. Machine can be sold with many extras or with the basics…. priced according to options included. PM or call me @SLP for details.
Last edited:
