2004 Firecat F7 Nightfire LE with factory EXT 144 kit. 3670 miles $3700
There were very few of this machine built. The entire hood, tunnel and skid were blacked out from the factory. Machine is curently located in Idaho Falls, Idaho but can be shipped or transported.
• SLP porting-Cylinders have been port matched to the cases..can have stock cylinders put back on if needed.
• New pistons, rings, water pump, bearings with custom lightweight wrist pins
• Crankshaft rebuilt and trued. Cases measured and blueprinted.
• V-Force III reeds
• All new electrical components including stator, coil and wires, caps and plugs
MSD low resistant wires and crimped caps
• PCV fuel controler
• Two sets of SLP pipes. One set cut for running higher RPM. One set ceramic coated
• Rear skid has been completely inspected with all new bearings and rebuilt shocks
• Mostly new front and rear suspension bushings and fresh grease
• Chassis has been completely disassembled, inspected and reassembled
• Throttle bodies have been synchronized, TPS calibrated to Cat specifications
• PCV
• Clutches completely rebuilt to new condition and re-balanced
• Alignment and offset have been perfectly set
• Arctic Cat factory race track 144”x14”x2” reversible finger track
• Custom ArcticFx wrap
This machine has had about 1.5 hours on the new motor. Chassis and motor have been completly gone through from top to bottom and are in excellent condition. Machine can be sold with many extras or with the basics…. priced according to options included....call for details.
Extras:
Trail pipes
Race pipes
Race heads
Team Tied Clutch
Ported cylinders
O2 guage
Powder Pro Ski's
Thanks,
Dustin Pancheri
208-317-1386
apexcarpetcleaning@rocketmail.com
There were very few of this machine built. The entire hood, tunnel and skid were blacked out from the factory. Machine is curently located in Idaho Falls, Idaho but can be shipped or transported.
• SLP porting-Cylinders have been port matched to the cases..can have stock cylinders put back on if needed.
• New pistons, rings, water pump, bearings with custom lightweight wrist pins
• Crankshaft rebuilt and trued. Cases measured and blueprinted.
• V-Force III reeds
• All new electrical components including stator, coil and wires, caps and plugs
MSD low resistant wires and crimped caps
• PCV fuel controler
• Two sets of SLP pipes. One set cut for running higher RPM. One set ceramic coated
• Rear skid has been completely inspected with all new bearings and rebuilt shocks
• Mostly new front and rear suspension bushings and fresh grease
• Chassis has been completely disassembled, inspected and reassembled
• Throttle bodies have been synchronized, TPS calibrated to Cat specifications
• PCV
• Clutches completely rebuilt to new condition and re-balanced
• Alignment and offset have been perfectly set
• Arctic Cat factory race track 144”x14”x2” reversible finger track
• Custom ArcticFx wrap
This machine has had about 1.5 hours on the new motor. Chassis and motor have been completly gone through from top to bottom and are in excellent condition. Machine can be sold with many extras or with the basics…. priced according to options included....call for details.
Extras:
Trail pipes
Race pipes
Race heads
Team Tied Clutch
Ported cylinders
O2 guage
Powder Pro Ski's
Thanks,
Dustin Pancheri
208-317-1386
apexcarpetcleaning@rocketmail.com
Last edited:
