just put on gravityworx cables,how do i set up oil cable?manual says 21mm,but thats more than the cable adjusts,looking for help.thanks
2000 mm700 oil injector settings
- Thread starter papacars
- Start date
put the two cable together and adjust the length so thier equal. make sure you see were the lever is on the oil pump so when you screw it in its at the same spot(starting point)Thread is about 1 1/2 in you can run the oil level on a stock cable to 18 mm on the cable, 21 is to fat. after your done watch your plugs so you dont melt another yammi !!!
I'm also having the same trouble getting it setup correctly. I did not pay attention to the old cable on how much it pulled the oil pump lever. I installed the new cable and adjusted it so it pulled the lever the full range. I ran ~60 miles and as I loaded it on the truck, the oil light came on. I measured the gas and oil that I replaced... it should be about 2.5-3 oz for every gallon. I wanted to make sure that I ran on the rich oily than seize the engine.
R
R
oiler cable
If it is using that much oil at 21mm you will have to go up in # like 22,23and so on. The pump is open to much at idle I am having the same problem. You want to shorten the cable housing with the adjustment in the middle of the cable so it lets the pump arm return closer to the close position on the pump .Make sure that your cable is completely seated in all the cable fittings
If it is using that much oil at 21mm you will have to go up in # like 22,23and so on. The pump is open to much at idle I am having the same problem. You want to shorten the cable housing with the adjustment in the middle of the cable so it lets the pump arm return closer to the close position on the pump .Make sure that your cable is completely seated in all the cable fittings
thanks guys
