Where do i get a 2.86 pitch drivers for the snow hawk. I want to mount a 154" track but understand I need to switch drivers?
2.86 pitch drivers
- Thread starter rustybarnard440
- Start date
Stock hawk is 2.52 pitch. I dont recall what the shaft hex size is but measure it then just order some from WPS threw your dealer of choice.
GOT my info I needed. From J&L snowhawk. 1.25" he's shaft.
7 tooth 2.86 pitch #54-2536 in WPS
Will allow a 2.5" lug
7 tooth 2.86 pitch #54-2536 in WPS
Will allow a 2.5" lug
Stock drivers are 9 tooth 2.52 so you can go with an 8 tooth 2.86 Avid driver That is a hair smaller than the stock 9 tooth .
I'm not sure about the Wahls and I think their diameter is a bit bigger and that might be the reason for the 7 tooth ?
I didn't want to drop 2 teeth because I was concerned about the gearing and I didn't want any more low end grunt .
http://www.backcountryrebels.com/showthread.php?t=34281&highlight=avid+drivers&page=8
thread #78
This style Avid is nice because it's designed for a little bit easy installation . I still had to put my foot against the other side of the tunnel though .
I'm not sure about the Wahls and I think their diameter is a bit bigger and that might be the reason for the 7 tooth ?
I didn't want to drop 2 teeth because I was concerned about the gearing and I didn't want any more low end grunt .
http://www.backcountryrebels.com/showthread.php?t=34281&highlight=avid+drivers&page=8
thread #78
This style Avid is nice because it's designed for a little bit easy installation . I still had to put my foot against the other side of the tunnel though .
