151 edge rmk tunnel will it fit on a wedge bulk head

[xc700]

Trying to find someone who has done this. I'am considering doing it myself. How much refabrication is required? Send pictures if you have them.

 

[Lil_Anvil_Breaker]

Another Question what trailing arm are you going to use? the edge trailing arms mount in the footrests where as the wedge mount on the outside of tunnel inside the outer edge. and the other issue is you will have to cut a hole for the drive shaft. depending on what your doing on the chaincase area

 

[Lil_Anvil_Breaker]

Not done this but with a lttle modding you should be fine

 

[xc700]

trailing arms and chaincase

I have a 98 xc so the trailing arms are set inside the belly pan so that shouldn't be to big of issue might need a little modification. I'm gonna run the edge rmk chainchase so that should all line up fine.

 

[Lil_Anvil_Breaker]

Forgot it was an XC model yeah it should make it easier Good Luck

 

[xc700]

ttt

 

[jgd]

The Edge/RMK chaincase is longer than the Wedge chaincase. I assume you're doing a D&R? If so it will work fine. Be prepared to cut new holes for the drive shaft. Jackshaft can stay where it's at. You should try and find a rivet align template. This was a fairly common drop and roll that you're doing. The tunnel should work fine, be prepared to do some cutting/ trimming as required. Also build yourself something to protect the chaincase (bottom). The plumbing may need some tweaking as well, all easily doable. Good luck.