08 m6 won't hold max rpms
Hey guys
Just picked up a 08 m6 notice that when I pin her in the powder she's not holding her rpms. So I put her in the shop and put her on the stand and tried it some thing she hit 7900 in the area then drop bad to like high 6 low 7. Notice servo motor opening for a like a sec and then closes. Clean up the valves same thing. Unplugged kill switch same thing. Any ideas?
Hey guys
Just picked up a 08 m6 notice that when I pin her in the powder she's not holding her rpms. So I put her in the shop and put her on the stand and tried it some thing she hit 7900 in the area then drop bad to like high 6 low 7. Notice servo motor opening for a like a sec and then closes. Clean up the valves same thing. Unplugged kill switch same thing. Any ideas?
Last edited:
