07 m8 check engine light - solid

[brahm]

Can't find any info on this but today when riding the check engine light came on but is not flashing any codes. It's staying on solid. Tried restarting and unplugging the ecm to no avail. Sled seems to run totally fine doesnt go into limp mode. At a loss any one else experience this? Unsure what to do

 

[jethrobodean]

I would ohm the temp sensor.....

 

[brahm]

I would ohm the temp sensor.....

The one that goes into the exhaust?

and wouldn't that give me a 1-7?

 

[sledtahoe]

temp gauge

it stays on at 200 degrees

 

[jethrobodean]

Not the pipe sensor, The water temp gauge.

 

[brahm]

thanks again, but I'm getting the check engine light, not the temp light, and it was doing it after letting the sled cool down for a while (and checked i have full coolant, and put snow on the exchange and it wasn't melting quick so it's not that hot).

On a side note fired it up the yesterday and no light at all.. sooo not sure what to think.

 

[brahm]

issue appears to have gone away.. gotta think it's moisture related.