06 ves troubles

[fyshstick101@hotmail.com]

so i disconected the solenoid and drilled the ves body and with the stock springs i have a bad bog on the top end so i tried running it without the springs and ended up having a bad bog up to 4000 rpm is their a lighter spring i can try or does anyone have any other sugestions? thanks for the help in advance

 

[SixtySevenGT]

Before the Mods --

Did it bog before drilling and Plugging ??

 

[SixtySevenGT]

You must leave the electrical Part hooked up

You must leave the Solinoid hooked up to the wires or the ECU will cut the engine out at about 6000..


Vacum hoses can be disconnected and plugged.

I run a white Spring Plugged.

 

[Danbot]

Drilled VES bodies, plugged hoses, stock springs.... 4-8k elevation here. Works great for me.

 

[fyshstick101@hotmail.com]

it did have a slight bog on the top end before it was when the sled was wide open going down a field or a trail after about a mile it would bog than if i let up on the throttle than grabbed it again it would be good for another mile or two than it would do it again i just cleaned the guilotines and they were very dirty

 

[05 tmk 900]

ves

do you have any pics of how to drill the ves ?
You just plug the vacuum hoses and that's it ?
I saw some pics once but can't find them
I see that slp sells different springs....
Thanks guys

 

[sno_mo_racer]

do you have any pics of how to drill the ves ?
You just plug the vacuum hoses and that's it ?
I saw some pics once but can't find them
I see that slp sells different springs....
Thanks guys

http://www.snowestonline.com/forum/showthread.php?t=228545