Anybody know if an 05 oil pump will work on an 06? Broke mine off of my 06 and am looking for a replacement.
Thanks,
Nolan
Thanks,
Nolan
05 to 06 oil pumps
- Thread starter nmmiles
- Start date
it should...look up the part numbers...
did you break it from using the drill when bleeding it
did you break it from using the drill when bleeding it
05 part#2520449
06 part#2520463
don't know what the diffrence is but part#S are not the same
06 part#2520463
don't know what the diffrence is but part#S are not the same
it should...look up the part numbers...
did you break it from using the drill when bleeding it
You have to use a drill to bleed the oil pump ....
WTF?
You have to bleed the oil pump with the motor out of the sled ....?
Broke the casting somehow. Everything was fine when I started it and then shut it off and discovered I had a SLOW oil leak. Traced it down and found out my oil pump had a crack through the casting.
Engine was in the chassis and I just hooked a drill up to the back side to fill the little lines leading to by bearings. Is that a bad thing?
-Nolan
Engine was in the chassis and I just hooked a drill up to the back side to fill the little lines leading to by bearings. Is that a bad thing?
-Nolan
not sure man..i never liked the drill idea anyways..
Dog..just fill the oil lines, and crack the bleed screw on the pump..mix you gas witha quart of oil and if you can hook a hnager on the pump lever when you start it and hold the lever wide open to bleed it..
your money..
not sure what to say nolan..too bad on the pump bro...check ebay..there was a really cheap one afew weeks ago..
Dog..just fill the oil lines, and crack the bleed screw on the pump..mix you gas witha quart of oil and if you can hook a hnager on the pump lever when you start it and hold the lever wide open to bleed it..
your money..
not sure what to say nolan..too bad on the pump bro...check ebay..there was a really cheap one afew weeks ago..
