carb

I’m looking PSI big air 46 mm. set 3 pcs. Please offer to me. Thanks. email: esman_art@hotmail.com

I purchased a 05 Summit 800ho this fall with 2200 miles on it. I cleaned the RAVE and they looked pretty bad. Right now it has a hanging idle after you ride it (3000 to 4000rpm but it does drop if your hit the chock for a couple seconds) Doesn't like to start in the cold, if its 0 degrees...

Im getting fed up with my ACCS (shocking that I still use it now). It worked up until the end of last season and it started running super rich. Since it backfires and runs rich, I want to jet the carbs and just change the jets when I go to wyoming. But Im not sure what to do with the hole in the...

I have a Boondocker NOS kit for Polaris Edge. Comes with 3.0 Alum bottle, Nitrous 2000 manifold, Adjustable regulator(turn the knob to adjust the shot), solenoid, lines, tees, "the button" and mounting bracket. This is a airbox mount spray kit. Asking $345 + shipping Thanks!

Hi.I Have a 02 xcsp 700 and the wife has a 01 supersport.I noticed that the airbox has 3 spots for a hose to hook to.On the supersport they are hooked to the mag side and the middle and on the 700 the are hooked to the middles and the clutch side.Any input would be greatly appreciated on where...

Polaris 40mm Racks - Sold I have a set of 40mm Polaris Mikuni racks. They worked just fine for me. I just don't need them anymore. I'm sure they'll work fine for you too...Also, one carb cover is tapped for a Holzman Ataac. You can just plug it off if you don't ran an Ataac. Asking $165 +...

I am looking for a 2007 or 2008 carb Polaris 600 H.O. motor. It is in a RMK 600 155". It is blown up in the lower end. I would like to replace with same thing and not go bigger. Thanks

I have K&N filters and want to know if anyone knows where I can get 90 degree elbows to make them vertical rather than horizontal. At the moment, they are rubbing on my jackshaft. In this case...that is a bad thing! :)

I went to adjust my carbs for the trygstad head. I pulled the carbs (what a pita so many hoses) then, then was able to change the pilot jets. Unfortunately I could not shim the needles as the Phillips screws on the top of the carbs stripped before they would break loose. I could have forced them...

hey guys need some baseline carb setups. Heres what i'm working with Have an 01 zr 800 black magic twin pipes and slp air box conversion no horns in box. the engine is stock no head work no reeds. What i need is help finding a good starting point for the main jet, if i have to jump sizes on the...