4. Position the HPS Silencer in place and re-install the spring-loaded bolt and tighten. Then re-attach the springs that connect the HPS Silencer to the stock pipe. Now insert the heat probe and tighten to slightly beyond snug, route the wiring harness over the Pyramid frame and plug in the wiring harness. Note: You may choose to use heat tape to protect the plastic shield that protects the electronics rather than re-attaching the stock heat shield housing.
5. Re-install the hood. Position it slightly forward and make certain the two body tabs on the nose are properly positioned to slide into their connections. Then make certain the two body tabs on the rear near the fuel tank are also properly aligned. Then slide securely into position. Re-insert the four bolts (two on the side by the end of the side panels and two on the top under the gauge housing).