T
Installing a BDX drive into the IQR . Have to run the BDX 10.4 Artic Cat style secondary & using my P85 primary.
I figure that the two stationary faces need to be a belt width apart ( inner primary face ID & outer secondary od ) but not sure if that would be idea alignment. When measuring the secondary face I would measure down from the top the thickness of the belt so & would be using ID belt measurements for both clutchs.
Thanks for your input or suggestion.
I figure that the two stationary faces need to be a belt width apart ( inner primary face ID & outer secondary od ) but not sure if that would be idea alignment. When measuring the secondary face I would measure down from the top the thickness of the belt so & would be using ID belt measurements for both clutchs.
Thanks for your input or suggestion.