Head and Jug Torque Pounds- M7

[Jred]

Anyone know?

 

[mocflats]

don't know if it is the same my buddy replaced a head gasket on a m1000 and a tech told him 24 ft/lbs for the head not sure about the jug

 

[M7highmark]

The jug torque is 29 to 44 foot pounds, the head torque is 23-26 foot pounds for the bolts with 4 marks on the head, and 13 to 20 foot pounds for the bolts with 3 marks. Good luck.

 

[Jred]

thank you

 

[RACINSTATION]

I dont like to torque the head bolts past 21 ft lbs with stock bolts. Snug them up to 18 first and then go back over them at 21.

Base bolts/nuts as stated above 44.

 

[m7cat]

Make sure to put the head on and torque it before you torque the cyl bolts so the head will line up. Best to set your Y-Pipe on to align it to the cylsbefor you tighten them also.