Anyone ever swap a Gen2 Holz skid in to 02 Edge

[maxrev3]

I purchased a Holz 151 skid for my 02 edge turns out the skid was from a 1999 gen 2 rmk after some basic measuring I found that the Holz mounting points are closer approx 28 inches center to center dist and the stock edge is
approx 30.5 inches and the front arm on the Holz is 1 inch shorter than the edge
which looks like it will put the skid 1 inch farther forward than the edge skid
Long story short Has anyone installed a gen2 holz skid in a 02 or later edge?
any help would be appreciated.
Thanks

 

[sled_guy]

I've done it, but I bought the new front arm from Holz (the Edge one) and converted the Gen II to an Edge.

I have one of those arms... it was spoken for by a guy, but let me check and if he doesn't need/want it I'll let you know.

At the time I did mine, Mark Holz was adamant about not being able to use the Gen II arm in an Edge.

sled_guy

 

[hudini]

I did the same exact thing as sled guy. You will need the tube that goes in the arm to bolt it to the tunnel.