S
03 Edge RMK 800 SOLD SOLD SOLD
SOLD SOLD SOLD
03 Edge RMK 800 159" Snowcheck Model
-Has Indy Dan Torque Master 3 Bottom end with Cat PTO end and New Cat Drive Clutch with 3 years of PTO warranty left
-PERC reverse, Team Tss-98 Secondary Clutch
-OEM Polaris pistons with about 200 miles on top end
-Aerocharger 53 Series Turbo
-Fresh Turbo from Turbo Doc Last year with new rotating assembly, was also checked this year before the season so it has one 200 mile trip on it since it was checked, about 600 miles total on the new assembly
-4 Screen Digatron with 2 egts, intake temp, water temp, RPM
-Autometer Boost and Fuel Pressure Gauges
-Cat M-series handle bars with Polaris left controls, FTX Billet Throttle Block and Handgaurds
-Br Tech Clear Hood with XXX mod rods vent kit along with vented belly pan
-Boss high rise flat top, with 3 gal tank in the seat
-Van Amburg Tunnel Widening/Snow Eliminator Kit
-Smaller U-Cooler under Rear
-Challenger 159" X 2 1/8" track
-Ryde FX Shocks all around w/Piggy Back Adjustable Rear
-Tri City Big Wheel 2 Wheel Rear Axle
-Wimpy's Swedged Lightweight Radius Rods
-New Pair of Yellow Powder Pros w/Black Loops
-Extra R&M mesh hood
Probably more that I'm not listing.
Sled is set up for 6lbs or 8lbs of boost with a switch to go between the two settings and runs on 50/50 c-12 Race Gas/Premium Pump Gas which is Probably Conservative for 6-9000 ft.
Come take it for a ride, it rips pretty good.
Pictured with Simmons Skis that are no longer on the sled
Located in SE North Dakota
Asking $3500 obo (no offer will insult me) or trades?
Need to Sell, would consider Selling Turbo Kit/Motor/Chassis Seperately
would also help with delivery within reason
Call with Questions (701) Three Seven One-7684
SOLD SOLD SOLD
03 Edge RMK 800 159" Snowcheck Model
-Has Indy Dan Torque Master 3 Bottom end with Cat PTO end and New Cat Drive Clutch with 3 years of PTO warranty left
-PERC reverse, Team Tss-98 Secondary Clutch
-OEM Polaris pistons with about 200 miles on top end
-Aerocharger 53 Series Turbo
-Fresh Turbo from Turbo Doc Last year with new rotating assembly, was also checked this year before the season so it has one 200 mile trip on it since it was checked, about 600 miles total on the new assembly
-4 Screen Digatron with 2 egts, intake temp, water temp, RPM
-Autometer Boost and Fuel Pressure Gauges
-Cat M-series handle bars with Polaris left controls, FTX Billet Throttle Block and Handgaurds
-Br Tech Clear Hood with XXX mod rods vent kit along with vented belly pan
-Boss high rise flat top, with 3 gal tank in the seat
-Van Amburg Tunnel Widening/Snow Eliminator Kit
-Smaller U-Cooler under Rear
-Challenger 159" X 2 1/8" track
-Ryde FX Shocks all around w/Piggy Back Adjustable Rear
-Tri City Big Wheel 2 Wheel Rear Axle
-Wimpy's Swedged Lightweight Radius Rods
-New Pair of Yellow Powder Pros w/Black Loops
-Extra R&M mesh hood
Probably more that I'm not listing.
Sled is set up for 6lbs or 8lbs of boost with a switch to go between the two settings and runs on 50/50 c-12 Race Gas/Premium Pump Gas which is Probably Conservative for 6-9000 ft.
Come take it for a ride, it rips pretty good.
Pictured with Simmons Skis that are no longer on the sled
Located in SE North Dakota
Asking $3500 obo (no offer will insult me) or trades?
Need to Sell, would consider Selling Turbo Kit/Motor/Chassis Seperately
would also help with delivery within reason
Call with Questions (701) Three Seven One-7684
Last edited:
