Long tracked pro-xr

I am close to being done and it is ready to ride. I have a 156 on a 2004 pro-xr factory race sled. I used Ice Age Manufacturing rails and I couldn't be happier. This is an unusual sled as it was the first rider forward sled Polaris made. The steering post goes over the engine and the trailing arms are a few inches shorter. You end up with a sled that feels a lot like my Summit Rev or a dragon.

The list of mods includes Rev Boss seat and tank, 700 VES engine, mbrp can, V Force 3, air pods, Fox Zero Pros all around set up by Carls cycle, 156 Camoplast Challenger track, Van Amburg tunnel extension, LED tail light, Vent kit from Mountain Fit, Aatac, Arctic Cat rear cooler

Pro-XR EXT

Nice work bro....I was going to do my 02' pro-x racer into a mountain sled...but everyone said it was too much work....how did the ice age rails work out for ya?? I talked to the guys at their booth at the swap in utah. Everything looked stellar.

Should I do it next year??

this is a 800 that i did in a 2002 440 chassis

curious to see how much it will transfer with that much rail behind the back suspension arms?

mattymac said:

curious to see how much it will transfer with that much rail behind the back suspension arms?

Click to expand...

It rode well when it was a 144" The geometry is the same as a stock 156 rear suspension. These rails are a direct swap for the stock 156" RMK suspension.