anyone install a storm motor in an edge chassis

polaris800 · Sep 22, 2008

What has to be done in order to bolt storm motor in an edge chassis? What type of motor plate, mounts, or use stock edge motor straps. Does motor need to be raised up for the water manifold in front of motor to clear the steering arm? Does it need to be shifted over towards the magneto side in order for clutches to line up? please leave a phone number if possible.

BB454 · Sep 23, 2008

Install

Should be very similar to a XCR install. Use Brad's plate and it will go real smothe. He probably will drill it for you. I beleive you will not need to raise the motor. The XCR has the wter pump on the case unlike the storm motor ant that is where the clearance issue is. The manifold on the storm is not as thick so I beleive it will clear. Shift it to the left makes for better clearance on the pipes and or air box. Use the bearing spacer on the jack shaft bearing that came on the storm/ultras.

801-712-7188
Gary

Search

anyone install a storm motor in an edge chassis

polaris800

New member

BB454

Free Member

Similar threads